WIT pneumatic --- MSQ-B-20A (ROTARY PNEUMATIC CYLINDER)

1.Brief Introduction:
(1) Rotary platform type,workpiece easy installation.roller bearing design.
(2) The load as large as CRQ series 3 to 4 times,swing smoothly and accurately.
(3) Hollow shaft can be used for the introduction of wire or climate.
(4) Standard device with a transfer point,adjust the angle range.
(5) Built-in magnetic ring,magnetic switch can be installed.
  

2.Techincal parameters:
(1) Medium - Air
(2) Action Way - Double Acting
(3) Working Pressure -
     Ajustment Bolts - 1.0MPa
     Shock Absorber - 0.6MPa
(4) Buffer - Rubber Buffer (Standard)
(5) Allow the force - 
     Ajustment Bolts - 0.025J
     Shock Absorber - 0.116J
(6) Minimun Operating Pressure - 0.1MPa
(7) Temperature Range - 0~60 Celsius Degree
(8) Angle Adjustment Range - 0~190 Celsius Degree
(9) Piston Diameter - 18mm
(10) Pipe Size - Rc (PT) 1/8

3.Cylinder Installation Instructions:
(1) Before installation,be sure if the cylinder was not damaged during transportation.check if connecting parts were loose,etc.
(2) When installation,the cylinder piston rod shall not with stand eccentric or radial loads,the load must be consistent with the direction of piston rod axis.
(3) When cylinder installation,especially for long stroke cylinder,it must use level instrument for three-point position calibration.
(4) Before the pipe connects into air intake,it should clear pipe's burrs,pipeline without corrosion,after cleaning up and checked,can be installation.
(5) Speed adjustment: firstly adjusting speed control valve (one-way throttle) in the middle,gradually adjusting the output pressure of regulator,when cylinder speed is close to pre-determine speed,it can ascertain working pressure,and then using speed control valve for fine tuning,Finally adjusting the buffer speed.
(6) After cylinder installation,in working pressure range,to operate 2-3 times without load,checking the cylinder before if is working normally.
(7) At high temperature or corrosive conditions,it should use the appropriate temperature or corrosion resistance cylinders.
(8) In the occasions of humidity,dust or water drop,oil,dust,welding slag,the cylinder should be protected with devices.
(9) In low-temperature environment,it should take anti-freeze measure to prevent water freezing of the system.